Wasp-bar-code WPL305 Uživatelský manuál stáhnout pdf (Strana 6)

Make sure both the ribbon access window and the printer top cover are

closed when powering up the printer.

3.3 Loading Label Stock

1. Insert a 1” label spindle into the label roll. If your paper core is 1 inch, you

can remove the 1.5” core adapters from the centering tab. If the label width

is 4 inches wide, the two centering tabs are not required.

Figure 4: Label Roll Installation

2. Open the printer’s top cover by pulling the yellow top cover open levers

located on each side of the printer and lifting the top cover. A top cover

support at the rear of the printer will hold the printer top cover open.

Figure 5: Pull the lever to open the cover

3. Place the roll of labels onto the center of the paper roll mount.

Lower Cover

1” Label Spindle

Printing Side

Face Up

1.5” Core Adapter

Centering Tab

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Žádné komentáře

Wasp-bar-code WPL305 Uživatelský manuál Strana 6